Page 1 of 1

How to Add Sprites?

Posted: Wed May 05, 2010 2:59 am
by (^_^)
Can't seem to add more section sprites-I only can figure out how to replace them.
Only goes up to section 24, and i even though i an add more, they don't ship up in shipmaker

Re: How to Add Sprites?

Posted: Wed May 05, 2010 3:11 am
by Maart3n
You have to drag the sprites into the shipmaker. Either when building your ship, or by going to tools then group arange.
Then you should save this new file for later.
Oh and you have 3 groups which can be switch by pressing ` and then the number corresponding with the group.

Re: How to Add Sprites?

Posted: Wed May 05, 2010 3:46 am
by vidboi
there's actually four groups to choose from. not sure what your problem is with not being able to insert sprites, but try using group arrange to add them

Re: How to Add Sprites?

Posted: Wed May 05, 2010 3:55 am
by Anna
#1. This is the wrong board for this question. This thread would be better suited to General Discussion or Shipmaking Info and Resources.

#2. READ THE FAQ.

Thread locked. ^^